Daily Archives: February 12, 2017

Solid wood paint furniture, furniture and other types of furniture, formaldehyde pollution sources

Solid wood paint furniture, furniture and other types of furniture, formaldehyde pollution sources Formaldehyde is the production of synthetic resin, paint, plastic and man-made fiber raw materials, wood-based panel industry is an important raw material. These residual or decomposed formaldehyde will gradually release to the surrounding environment, the longest release …

Read More »

China PLYWOOD Sanding /Polishing Production Process Control decide the final plywood thickness and surface

胶合板砂光过程应该注意的问题 砂光前,需要严格执行测量砂光前的胶合板厚度。 砂光后,需要严格执行测量砂光后的胶合板厚度。防止砂穿/透,或者漏砂偏砂。 砂光机操作员需要严格控制遵守砂光操作程序和要求。 出了砂光的问题,需要及时的上报给班长和车间主任及厂长。 Plywood sanding process should pay attention to the sanding problems Before sanding, you need to strictly measure the thickness of the plywood before sanding. After sanding, it is necessary to strictly perform the measurement of the plywood thickness after sanding. To prevent sand through , …

Read More »

The birch veneer laminating production process of birch plywood

白桦多层板贴面生产工艺 The birch veneer laminating production process of birch plywood 一、基材分选: First, the substrate separation/sorting: 基材应有足够的胶合强度,不得有鼓泡、脱胶和边角缺损现象,无大裂隙和离叠芯。板面不得有起皱,重叠。 There should be enough glue strength in the base substrate panels, no blister, degumming and corner defect. The Board shall not wrinkle, overlap. 基材表面光洁平整,无明显翘曲,翘曲度不超过1%。 The substrate surface is smooth, no obvious warpage, warpage is not …

Read More »