Daily Archives: 5 months ago

New environmental protection standards for furniture

New environmental protection standards for furniture 2018-04-27 Source: The Beijing News On February 1, the “Technical Requirements for Environmental Labeling Products Furniture (HJ 2547-2016)” issued by the Ministry of Environmental Protection was formally implemented and the “Technical Requirements for Environmental Labeling Products Furniture” (HJ/T 303-2006) was abolished. Furniture products will …

Read More »

Formaldehyde emission in wood based panels: Effect of curing reactions

Formaldehyde emission in wood based panels: Effect of curing reactions https://www.researchgate.net/publication/265599308_Formaldehyde_emission_in_wood_based_panels_Effect_of_curing_reactions Abstract The influence of hexamine formed as byproduct during the UF cure was ignored in the past. However, with the increasing interest on low formaldehyde emission boards, this issue has become more pertinent. Formaldehyde release from hexamine degradation is …

Read More »

Formaldehyde and VOC emissions at different manufacturing stages of wood-based panels

Formaldehyde and VOC emissions at different manufacturing stages of wood-based panels Source https://www.sciencedirect.com/science/article/pii/S036013231100237X Abstract Formaldehyde and VOC emissions from wood-based panels are recognized as one of the major causes of poor indoor air quality. These emissions may be strongly influenced by the raw materials and manufacturing techniques of the panels. However, …

Read More »

Solid Timber Door Blanks Site Storage, Protection & Conditioning Guidance

Solid Timber Door Blanks Site Storage, Protection & Conditioning Guidance In order for timber door-blanks to perform satisfactorily in use, it is essential that the following guidance is adhered to, both prior to and following installation: Sealing and priming of doors should be carried out immediately after delivery to site. Doors should be …

Read More »

MARINE PLYWOOD To BS1088-1:2003

MARINE PLYWOOD To BS1088-1:2003 General Description: Marine Plywood is manufactured from a selection of hardwood species. The board is normally manufactured with an odd number of plies, each ply being oriented at 90 degrees to the one bonded to it, to create a balanced construction. The face and reverse veneers are …

Read More »

Conditional Of Wood-Based Panel Products

Conditional Of Wood-Based Panel Products The wood fibre in wood-based panel products will continue to do what wood has always done; that is, absorb moisture from its environment until it reaches equilibrium. To prevent distortion of the panel it will need conditioning. What is conditioning? Conditioning, in relation to panel products, is the …

Read More »

Film, Mesh And MDO Faced Plywood User Guide

Film, Mesh And MDO Faced Plywood User Guide In order for film, MDO & mesh faced plywood to perform satisfactorily in use, it is important that the following guidance is followed before, during and after installation:   Plywood of all types must be stored horizontally on a level surface, supported …

Read More »

UV prefinished Engineered Veneer (EV) plywood Manufacturing Process need more Paint

UV prefinished Engineered Veneer (EV) plywood Manufacturing Process need more Paint Because of its special production process and finished veneer quality ,it need more UV paint than regular natural wood face veneer ,the surface is not smooth like natural veneer ,so need more paint to fill the uneven surface ,smoothly …

Read More »