Plywood Manufacturing Experience and Manufacturing Knowledge

Plywood Manufacturing Experience and Manufacturing Knowledge

MELAMINE MDF  PRODUCTION PROCESS

MELAMINE MDF  PRODUCTION PROCESS The MDF board is sourced out from reputed international manufacturers and undergoes a strict quality control inspection for consistency in thickness and density of material as well as its modulus of elasticity, tensile strength, bending strength and moisture content. An additional test for boiling water resistance …

Read More »

Plywood labeling and formaldehyde in plywood testing

Plywood labeling and formaldehyde in plywood testing 1.How you mark the plywood with label ,the glue types 2.How often you test your EPA or CARB P2 or Domestic E0 glue ? 3,have you tested your glue ? 4.Have you tested the finished plywood ? 5.how you make the outside label …

Read More »

En636-1, 2 and 3 plywood requirements

When doing with the european customers ,take care of their actual requirements of En636-1, 2 and 3 for plywood . If you can understand fully meaning and requirements ,it will reduce your selling risks . If you can not understand ,ask the customers provide you to see if you can meet …

Read More »

Formaldehyde emission in wood based panels: Effect of curing reactions

Formaldehyde emission in wood based panels: Effect of curing reactions https://www.researchgate.net/publication/265599308_Formaldehyde_emission_in_wood_based_panels_Effect_of_curing_reactions Abstract The influence of hexamine formed as byproduct during the UF cure was ignored in the past. However, with the increasing interest on low formaldehyde emission boards, this issue has become more pertinent. Formaldehyde release from hexamine degradation is …

Read More »

Formaldehyde and VOC emissions at different manufacturing stages of wood-based panels

Formaldehyde and VOC emissions at different manufacturing stages of wood-based panels Source https://www.sciencedirect.com/science/article/pii/S036013231100237X Abstract Formaldehyde and VOC emissions from wood-based panels are recognized as one of the major causes of poor indoor air quality. These emissions may be strongly influenced by the raw materials and manufacturing techniques of the panels. However, …

Read More »

Solid Timber Door Blanks Site Storage, Protection & Conditioning Guidance

Solid Timber Door Blanks Site Storage, Protection & Conditioning Guidance In order for timber door-blanks to perform satisfactorily in use, it is essential that the following guidance is adhered to, both prior to and following installation: Sealing and priming of doors should be carried out immediately after delivery to site. Doors should be …

Read More »