Plywood Types and Knowledge

Plywood Types and Knowledge

Plataform

Plataform Plataform is a raw material of the plywood, where the customer chooses in its factory what he is going to put on the face and back of the finished plywood.  A product with high levels of quality to comply with the international plywood industries requirements Plataforms can be made …

Read More »

HARDWOOD PLYWOOD – GLOSSARY OF TERMS

HARDWOOD PLYWOOD – GLOSSARY OF TERMS BACK – The side reverse to the face of a panel or the poorer side of a panel in any grade of plywood calling for a face and back. BALANCED MATCH – Two or more veneer components or leaves of equal size to make up a …

Read More »

MR E0 E1 E2 F4 CARB NAUF Formaldehyde Emission Plywood

MR E0 E1 E2 F4 CARB NAUF Formaldehyde Emission Plywood E0, E1, E2 all refer to an environmental protection standard for formaldehyde emission limit. The first two standards E1 and E2 were produced in Germany, which was formulated by “EGGER” and then introduced as European standard. The highest standard in …

Read More »

Plywood labeling and formaldehyde in plywood testing

Plywood labeling and formaldehyde in plywood testing 1.How you mark the plywood with label ,the glue types 2.How often you test your EPA or CARB P2 or Domestic E0 glue ? 3,have you tested your glue ? 4.Have you tested the finished plywood ? 5.how you make the outside label …

Read More »

En636-1, 2 and 3 plywood requirements

When doing with the european customers ,take care of their actual requirements of En636-1, 2 and 3 for plywood . If you can understand fully meaning and requirements ,it will reduce your selling risks . If you can not understand ,ask the customers provide you to see if you can meet …

Read More »

Formaldehyde emission in wood based panels: Effect of curing reactions

Formaldehyde emission in wood based panels: Effect of curing reactions https://www.researchgate.net/publication/265599308_Formaldehyde_emission_in_wood_based_panels_Effect_of_curing_reactions Abstract The influence of hexamine formed as byproduct during the UF cure was ignored in the past. However, with the increasing interest on low formaldehyde emission boards, this issue has become more pertinent. Formaldehyde release from hexamine degradation is …

Read More »

Formaldehyde and VOC emissions at different manufacturing stages of wood-based panels

Formaldehyde and VOC emissions at different manufacturing stages of wood-based panels Source https://www.sciencedirect.com/science/article/pii/S036013231100237X Abstract Formaldehyde and VOC emissions from wood-based panels are recognized as one of the major causes of poor indoor air quality. These emissions may be strongly influenced by the raw materials and manufacturing techniques of the panels. However, …

Read More »