CUT TO SIZE Plywood inspection and QC checklist

CUT TO SIZE Plywood inspection and QC checklist

胶合板锯开之后,尺寸要精确,长度和宽度精准,不能有开胶分层的现象,锯开之后的四边的厚度要一致,厚度公差要一致,芯板层次清晰,严格控制叠芯和离芯,不能有锯齿和黑色的糊边现象,边部不能起皮,切割胶合板,不能有切口位置崩边, 胶合板不能有变形或者翘曲。

After the plywood is sawed, the size should be precise, the length and width should be precise and quite accurate, and there should be no delamination. After sawing, the thickness of the four plywood sides should be the same, the thickness tolerance should be the same, the core veneer  should be clear and straight , the core voids and overlaps should be strictly controlled, there should be no face veneer or top veneer delaminated phenomenon, no peeling at the plywood edge, no edge collapse at the cutting position, no deformation or warping of the plywood.

锯片精度好一点,锋利一点,锯齿多一点,走得慢一点,锯片出的少一点,转速快一点,效果会好一点。

The saw blade has better precision, sharper, more serrated teeth, slower walking, less blade output, faster speed, and better effect.This blade provides flawlesschip-free edges inveneered plywoods .The small teeth take little bites to reduce chip-out and are steeply beveled at their edges to score the veneer face. You’ll have to slow your feed rate, but will get a much smoother edge.

The QC should check if there are rough, splintered edges when cutting plywood , get minor tear-out of small fibers.

Check Also

Plywood grade

Plywood grade Ordinary plywood is divided into four grades according to the material defects and …

Leave a Reply

Your email address will not be published. Required fields are marked *