European Technical Assessment for I Joists

European Technical Assessment for I Joists

EU Guidelines for I Joists

There is currently no harmonised European standard for I-joists so manufacturers have to apply for a European Technical Assessment. This is made through a Technical Assessment Body (TAB) to the European Organisation for Technical Assessment (EOTA).

IJoist Flooring without DeckingThe ETA provides a way for the manufacturer to CE-mark a product. For I-Joists, it provides information about the performance of a construction product to be declared in relation to its essential characteristics.

An ETA is issued on the basis of a European Assessment Document (EAD). This sets down the procedures needed to fulfil this under the new Construction Products Regulation.

EADs are replacing the old Guideline for European Technical Approval of Light Composite Wood-based Beams and Columns which currently still defines I-Joists (etag-011-en.pdf). An EAD for I-joists will be implemented by December 2020. Until then, the ETAG 011 will continue to be used as the harmonised technical specification.

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our articles infringe on your copyrights and interests, please email us at info@plywoodinspection.com in time and we will delete it at the first time.

Check Also

plywood complies with the following CE certification requirements

CE2+ CERTIFICATION plywood complies with the following CE certification requirements: i)       EN 636-3 S (Structural …

Leave a Reply

Your email address will not be published. Required fields are marked *