Formwork beam H20 inspection and QC checklist

Formwork beam H20 inspection and QC checklist

These Wooden beam designed for reticular formwork, flat beams, walls and civil Works,the basic rule is the safety guarantee .When inspect these formworks products ,pay more attention on the safety checking .Offering innovative products adapted to the needs of formwork, providing a high level of safety, quality and improving work costs.

  • Beam

    Wooden beam for formwork consisting of two upper and lower wooden wings and a central section consisting of three layers. The union is designed as a notched and glued joint.


    Fir and Pine ,eucalyptus wood of the highest quality, calibrated with levelled edges and with finger type joints along their length.


    Of a three-layer board with a thickness of 27 mm.

    Protected Beam End

    Anti-shock polymer caps specifically designed to last longer on site.

  • Joint

    Notched, finger-type joint between core and wings, throughout their length. High-frequency, high-strength gluing.

    Anti-Humidity Treatment

    Protective paintwork throughout the beam.

  • Strength and Safety

    Dimensional stability and recovery capacity after application of load. High load capacity throughout their length. Protection against humidity, knocks and splintering.


    Easy handling and quick assembly. Minimum weight.

  • Economical

    Can be used many times. Good ratio between price and uses. Easy storage.

    Adaptability to Building Work

    Ideal for use with three-layer board. The beam can be cut at any point. Supports can be placed between beams at any point. Can be used in any kind of formwork.

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source,If you find that our articles infringe on your copyrights and interests, please email us at in time and we will delete it at the first time.

Check Also

Requirements on substrate treatment for installation of film faced plywood

Requirements on substrate treatment for installation of film faced plywood During the installation of film …

Leave a Reply

Your email address will not be published. Required fields are marked *