Full throughout Birch plywood Grades and standards

Full throughout Birch plywood Grades and standards

Full throughout Birch plywood sanded on both the faces. Birch plywood has a wide range of application. Plywood is composed of 1.4 mm thick veneers by cross bonding.

B (I) – for high quality painting, staining and lacquering.

S (II) – for good quality painting, staining and lacquering.

BB (III) – for interior paint finish and coating with transparent and non-transparent thicker overlays and films, and also veneering.

WG (IV) – for use where surface appearance is not important, reverse grade.

WGE is WG grade plywood where all open defects – splits, knot holes, intergrown knots with splits, peeling defects, imprints and holes are repaired with putty. Unsanded areas are not permitted.

1220 mm x 2440 mm
1250 mm x 2500 / 2750 / 3000 / 3340 / 3660 mm
1500 mm x 3000 mm
1525 mm x 2500 / 2750 / 3050 / 3340 / 3660 mm
2150 mm x 3050 / 3340 / 3850 mm

Long grain birch plywood panels with the length up to 2500 mm are also available. Cut-to-size panels and machining available in accordance with the customers’ requirements.

Thicknesses

4, 6.5, 9, 12, 15, 18, 21, 24, 27, 30, 35, 40, 45, 50 mm

Check Also

Factors Influencing the Quality of Plywood

Factors Influencing the Quality of Plywood 1. Adhesive quality The performance of synthetic resin adhesives …

Leave a Reply

Your email address will not be published. Required fields are marked *