H 20 I-beams, H 20 building beams,

H 20 I-beams, H 20 building beams,

Grade: I Specification: H20 Moisture Content: 12% Bending Strength: Name: Forward Plank Tree Species: Pine Special Function: Not Easy to Split Apparent Density: Brand: Yelu Wood Construction I-beam H20 Product Characteristics: H20 BEAM H20 I-beam H16 I-beam Imported Wood I-beam H20 Wood I-beam Pine I-beam I-beams for building beams I-beams Plastic Baotou H 20 I-beams Wood I-beams Load-bearing I-beams New Zealand Radial Pine building beams. The best substitute for solid wood I-beams and steel I-beams.

A I-beam H20 flange: high quality pine; stable B I-beam H20 web: multi-layer board; durable; strong bearing capacity C construction I-beam H20 end protective film: moisture-proof and ultraviolet protection; reduce wear and tear; improve service life. I-beam H20 technical parameters: unit weight: 4.6kg/m flange width: 80mm flange thickness: 40mm web thickness: 27/30mm elastic modulus E: 10N/mm2 allowable deformation quantity: l/(l=support width meter) active load: 1.5KN or 20% concrete load calculation I-beam H20 specification for construction main material: poplar/pine LVL (web) +flange pine Wood LVL_I-beam H20 flange thickness: 40 mm I-beam H20 web thickness 27/30 mm I-beam H20 product price: 35 yuan/m glue: WBP_I-beam H20 applicable scope: can be used for civil engineering construction, bridges, tunnels, nuclear power stations, civil engineering and other civil engineering I-beam H20 standard length: 2.452.652.903.303.603.904 504.905.90m. I-beam H20 can also produce wood beams with different length or thickness webs (less than 6 meters) according to different needs.

The H20 I-beam is an important component of the international common building formwork system. It has high strength, light weight and strong bearing capacity.

It can reduce the number of supports, enlarge the space and construction space, make assembly and disassembly convenient, flexible and easy to assemble and disassemble in the field.

Surface water resistance, saving labor and materials and other characteristics can be used for many years, the comprehensive cost amortization cost is much cheaper. I-beam H20 is a weatherproof adhesive bonded with solid wood sawn timber as flange and multi-layer board as web to form I-section surface.

A lightweight structural member coated with anticorrosive and waterproof paint. 2. The construction I-beam H20 can be used in the cast-in-situ reinforced concrete formwork with multi-layer slabs and vertical supports to form a level.

The vertical formwork system can be formed by supporting the formwork system with multi-layer plates, diagonal braces and tension bolts.

3. The most prominent characteristics of H 20 I-beam for construction are large stiffness, light weight and strong bearing capacity, which can greatly reduce the number of supports and enlarge the spacing.

And construction space; easy to disassemble and use, flexible and easy to assemble and disintegrate in the field; low cost, durable, high reuse rate.

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our article infringes on your rights and interests, please email us in time and we will delete it at the first time.

Check Also

Material of I-beam

Material of I-beam The two wings are dried pine with moisture content below 13%. The …

Leave a Reply

Your email address will not be published. Required fields are marked *