How to minimise Distortion (Bow and Twist) in plywood

How to minimise Distortion (Bow and Twist) in plywood

1,Do not use any new panels showing bow or twist out of the pack. Where distortion exceeds 30mm, these panels fail the product standard. They should not be used and returned to the manufacturer.

2.Prevent/Minimise Exposure to Moisture Where plywood panels that have been supplied flat on site distort, there is only one cause, this is exposure to moisture, or a change in moisture content.

3.No plywood manufacturer provides any warranty where flat plywood sheets distort on a jobsite due to exposure to moisture or weather.

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our articles infringe on your copyrights and interests, please email us at info@plywoodinspection.com in time and we will delete it at the first time.

Check Also

China high pressure laminates GB Standards

https://www.gbstandards.org/GB_Search.asp?word=high+pressure+laminates GB standards are the China national standards; Prefix code GB are Mandatory standards, GB/T are Recommended standards; All products …

Leave a Reply

Your email address will not be published. Required fields are marked *