How to Use Film faced plywood for Spray Painting

How to Use Film faced plywood for Spray Painting

Film faced plywood assembly should be assembled as a whole in strict accordance with the size of the Film faced plywood matching drawing. When the Film faced plywood is assembled on site, the seams between adjacent Film faced plywood should be controlled well. Clamps should be installed at the joints of the two Film faced plywood to prevent slurry leakage. After assembly, the Film faced plywood and the vertical steel pipe should be tied firmly with steel wire to maintain the integrity of the Film faced plywood.

The assembly accuracy requirements are as follows:

1. The seam between the two Film faced plywood is less than 1.

2. The difference between adjacent Film faced plywood is less than 1.

3. Film faced plywood flatness < 2;

4. Film faced plywood dimension deviation (+3);

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our articles infringe on your copyrights and interests, please email us at info@plywoodinspection.com in time and we will delete it at the first time.

Check Also

F14 Structural Form Ply Inspection,grading,quality control,sourcing ,manufacturing

    Premium Form F14 Structural Form Ply – achieve concrete forming that results in …

Leave a Reply

Your email address will not be published. Required fields are marked *