Inner components (for upholstering) inspection,quality control,testing,factory auditing,suppiers sourcing,buying guide

  • Inner components (for upholstering)
  • – Pressed blanks from B-C-D grade veneer (contour-cut or uncut “blanks”). The strength of beech plywood allows the use of molded plywood as a frame base for foam rubber and the fabric of an office chair or other chair. It is possible to install metal parts, “T-nuts”, other elements of installation.

 

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our articles infringe on your copyrights and interests, please email us at info@plywoodinspection.com in time and we will delete it at the first time.

Check Also

Molded, Bent Plywood Seating Components | Producer quality control,inspection,sourcing,buying guide,factory auditing ,Supplier audit, Vendor Survey ,supplier evaluation, quality assurance

The implementation of various furniture forms and designs with a relatively low cost of production …

Leave a Reply

Your email address will not be published. Required fields are marked *