Marine Plywood AS/NZS 2272 : 2006

Marine Plywood

Marine plywood is manufactured to AS/NZS 2272 : 2006 Plywood – Marine. Unless otherwise branded

Marine plywood has a minimum stress grade of F14 and therefore has an associated suite of structural

properties. However, it should be noted the veneer arrangement and veneer thicknesses used in marine

plywood commonly result in different section properties to those for structural plywood of the same

thickness. Therefore these two plywoods are not usually directly substitutable for each other for the

same structural application. Marine plywood is manufactured with higher quality veneers and usually has

more veneer layers and thinner face veneers. This provides more uniform section properties in both

directions but lower stiffness and strength in the face grain direction than an equivalent thickness structural

plywood. Structural plywood with thicker face grain veneers will be stiffer and stronger in the face grain

direction and is the plywood type intended for use in structural applications described in this manual.

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source,If you find that our articles infringe on your copyrights and interests, please email us at in time and we will delete it at the first time.

Check Also

China blockboard Standards,GB standards,english version GB/T 5849-2016 PDF English. – Chinese Standard GB/T;GBT;GB GB standards are the China national standards; Prefix code GB are Mandatory standards, GB/T are Recommended standards; All products …

Leave a Reply

Your email address will not be published. Required fields are marked *