OPTIMAL HANDLING OF FILMFACED PLYWOOD

OPTIMAL HANDLING OF FILMFACED PLYWOOD
Proper handling instructions – so clients can bring the best out of our filmfaced plywood: 

fg7Sealing of the edges

The edges of plywood panels coated with special paint are sealed at the factory. It is very important that panels edges are kept sealed. They should be re-painted after cutting to prevent water from entering the panel.

 

fg8Sealing of drilled holes

Newly drilled holes have to be sealed properly to avoid penetration of water.

Cleaning

The surface should be cleaned immediately after the detaching the board from the concrete surface.
Film-faced plywood can be cleaned with conventional solvents or with water and a suitable natural brush (not metalic).

Storage

Film-faced plywood surface should be properly cleaned before stored.
Panels should be dried slowly and fully before storing.

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our article infringes on your rights and interests, please email us in time and we will delete it at the first time.

Check Also

Kitchen cabinet Construction quality control and inspection checklist

Kitchen cabinet Construction quality control and inspection checklist https://www.barkercabinets.com/Barker-Cabinet-Specifications-s/245.htm   如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special …

Leave a Reply

Your email address will not be published. Required fields are marked *