Particle Board QC Inspection Checklist : Part 3 Structure of PB

Particle Board QC Inspection Checklist : Part 3 Structure of PB

• Particles of mm dimensions
• Typically 3 layers – surface or
face material of fine particles
• Core material of coarser
material (larger chips)
• Density profile developed
during manufacture
– Improved properties in bending
– Harder surface

 

Structure of PB
Structure of PB

Range of differing physical, mechanical & other properties,
including:
– Strength (bending, transverse tensile, shear)
– Stiffness (bending)
– Density
– Surface hardness
– Screw holding
– Colour
– Surface “finish” (roughness)
– Moisture resistance
– Creep (long term deformation under a sustained load)
– VOC emissions

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our article infringes on your rights and interests, please email us in time and we will delete it at the first time.

Check Also

CARB (California Air Resource Board) Phase 2 Certificates

CARB (California Air Resource Board) Phase 2 Certificates CARB (California Air Resource Board) Phase 2 …

Leave a Reply

Your email address will not be published. Required fields are marked *