Physical and mechanical performance of Film faced plywood TESTING

Physical and mechanical performance of plywood specifications TESTING Parameter

Parameter name categories :

1 Moisture content, %

2 Ultimate static bending strength:
—along the grain of face veneers, MPa, min
—against the grain of face veneers, MPa, min

3 Modulus of elasticity in static bending:
—along the grain, MPa, min
—against grain, MPa, min

4 Ultimate tensile strength along the grain of face
veneers, min MPa
5 Adhesion strength of coating to plywood :Coating must not delaminate at the crossing point of two cuts

6 Steam resistance :No swelling. Small loss of gloss. No blisters.

7 Sodium hydroxide (NaOH) resistance :Solution color after testing (NaOH) from light yellow to colorless

8 Cement resistance: No cement coloration after contact with plywood

Average ultimate shear strength along the glueline, MPa

Notes:
1 EXT (FSF) plywood is prepared to testing using one of the four following methods:
—boiling in water for 1 hour;
—soaking in water for 24 hours at 20±3°C, boiling in water for 6 hours;
—soaking in water for 24 hours at 20±3°C, boiling in water for 4 hours, drying in a ventilated cabinet
for 16-20 hours, second boiling in water for 4 hours, cooling in water for 1 hour;
—soaking in water for 24 hours at 20±3°C, boiling for 72±1 hours, cooling in water for 1 hour;
Preparation method is chosen by agreement with the customer.
2 Percentage of destruction in wood is determined visually
3 Shear testing is performed in different glue lines by agreement with the customer

Check Also

Study on Forming manufacturing process of Plywood

Study on Forming manufacturing process of Plywood What is the difference between one-time forming  manufacturing …

Leave a Reply

Your email address will not be published. Required fields are marked *