Plywood MANUFACTURING Defects pART 2 Checking

Plywood MANUFACTURING Defects pART 2 Checking

Checking: The appearance of checks as described above anywhere on a veneer face. Concentration may be isolated to small areas or widely dispersed over the entire panel surface. Often associated with maple due to the stresses inherent in that genus.

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com

Check Also

Small Stories in Plywood Quality Control Industry Part 5

Small Stories in Plywood Quality Control Industry Part 5 The True Story of Quality Control …

Leave a Reply

Your email address will not be published. Required fields are marked *