Plywood Slicing Information

Plywood Slicing Information

Oringal please visit https://www.andersonplywood.com/plywood-slicing-information/

Hardwood and decorative softwood veneers which are the visible faces of hardwood plywood panels are cut from the trunk or root of the tree. The tree is sliced up into thin sheets of wood called flinches. These flinches are then glue-stitched together in various matching sequences (see plywood matching) to create the face and back veneers of plywood panel.

The manner and angle of the slicing produces different grain patterns in the flinches creating the final appearance of the panel.

Plywood Slicing Types

Images © Compliments of Saunders Wood Specialties, Inc.

Rotary Cut

The entire log is cut or “peeled.” It can yield full sheets of veneer with broad grain pattern and no plain or quarter-sliced appearance.

Quater Slicing

This method produces a series of stripes — straight in some woods, varied in others. A flake pattern is produced when slicing through medullary rays in some species, principally oak. Most species produce the same look as rift cut.

Plain Slicing

The half log, or flitch, is mounted with the heart side flat against the flitch table of the slicer. The slicing is done parallel to a line through the center of the log to produce a distinct figure

Rift Cut

A cut angle of 15 degrees to the radius of the flitch is us

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our articles infringe on your copyrights and interests, please email us at info@plywoodinspection.com in time and we will delete it at the first time.

Check Also

Rotary Cut PLB veneer inspection,sourcing ,quality contorl ,manufacturing consultant service

PLB veneer Size : 8×4,7×4,6×4, 7×3,6×3 Thickness: 0.15-0.60 mm Grade : A, AB, B, C, …

Leave a Reply

Your email address will not be published. Required fields are marked *