Pre-cutting platforms before birch face veneer lamination

Pre-cutting platforms before birch face veneer lamination. It’s an extra step most others mills avoid. However, most of the mills have the ability tightly control production and not skimp on important additional steps like this, which ultimately results in better plywood.

It can reduce the problems caused by foreign garbage and increase the bonding strength of face veneer lamination .

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our article infringes on your rights and interests, please email us in time and we will delete it at the first time.

Check Also

  OSB PANEL Manufacturing process 

  OSB PANEL Manufacturing process 

OSB PANEL Manufacturing process An oriented strand board (OSB) is a structural panel composed of …

Leave a Reply

Your email address will not be published. Required fields are marked *