Quality Standards and Classification of Core Board (Poplar Veneer, Eucalyptus Veneer) by Wood Industry Association

Quality Standards and Classification of Core Board (Poplar Veneer, Eucalyptus Veneer) by Wood Industry Association

Material: Poplar veneer and Eucalyptus veneer

2. Quality requirements:

(1) Special panels:

1. A small amount of dead knots and wormholes are allowed on the surface of the plate.

2. No digging and repairing

3,<3mm crack; no laminated core

4. No uneven thickness (thin)

5. No short ruler

6. No scales

(2) Subpanels:

1. It is required that there are no falling dead joints on the plate surface and the diameter is less than 20 mm. Three patches are allowed and less than 200 x 300 mm are allowed.

2. No dead knots and wormholes on the surface of the plate

3. No uneven thickness (thin)

4. No short ruler

5. No scales

(3) jigsaw puzzle:

1. Allow 2-6 Jigsaw

2. It is required that there is no falling dead joint on the plate surface and the diameter is less than 20 mm. Patches are allowed and less than 20 mm are allowed.

There are three places of 200 x 300 mm.

3. No dead knot and wormhole on the surface of the plate

4. No uneven thickness (thinner, repaired)

5. No short ruler

6. No scales

(4) Hole board: It is allowed to repair more than 200 *300mm hollow board, and less than 5 places.

Specification requirements:

The diagonal error of panel with length 1270 mm x width 620 mm or 840 mm is less than 5 mm.

Thickness: 1.2-3.2mm (thickness error < 0.2mm)

4. Dry Humidity: Moisture <12~16%

Fifth, the board surface: to be flat, no decay, mildew, no springboard (fish scale board), no more than 1/5 depth of knife mark plate.

Sixth, the requirement of graded packaging, must be hot-pressed leveling!

KEYWORDS :China Veneer Poplar, Veneer Poplar Manufacturers, Suppliers |,Poplar Wood Veneer,2-Ply Poplar Veneer,Poplar Wood Veneer,Yellow Poplar,Tulipwood,American Poplar,White ,

poplar veneer plywood,

wood veneer,

poplar wood,

rotary cut poplar veneer,

walnut veneer,

maple veneer,

mahogany burl veneer,

veneer scraps1.,

 

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our article infringes on your rights and interests, please email us in time and we will delete it at the first time.

Check Also

British Standard 1088 (Joubert Okoume & Hydrotek Marine Meranti) GRADING RULES

British Standard 1088 (Joubert Okoume & Hydrotek Marine Meranti) GRADING RULES B.S. 1088 : 1966 …

Leave a Reply

Your email address will not be published. Required fields are marked *