Study on Forming manufacturing process of Plywood

Study on Forming manufacturing process of Plywood

What is the difference between one-time forming  manufacturing process and multiple forming manufacturing process  of plywood? What is one-time manufacturing process ? Is pre-pressing and hot-pressing one-time forming manufacturing process ? What’s the difference between the two manufacturing processes? For example, strength and so on.

Before the film is coated, the substrate is made and then the three-piece board is made.

Plywood generally needs to be laid out, pre-pressed, hot-pressed, scraped greasy, sanded, trimmed and film covered.

After hot pressing, the base plate is not scraped greasy and sanded. After the overlay is made into three pieces, the plywood is scraped greasy, sanded, trimmed and film covered.

Secondary forming  manufacturing process needs to complete all the processes to sanding to make a substrate, and then cover into three pieces of board, and then pre-press, hot-press, scrape greasy, sanding. Finally, the plywood is cut and film coated.

 

There is no difference in strength between primary and secondary plywood moulding manufacturing process . Secondary moulding  manufacturing process is more meticulous in workmanship and more closely bonded in the middle because of the small gap after scraping and sanding.

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our article infringes on your rights and interests, please email us in time and we will delete it at the first time.

Check Also

Formaldehyde emission standard of wood-based panels E0 E1 E2

Formaldehyde emission standard of wood-based panels E0 E1 E2 Formaldehyde emission standard of wood-based panels …

Leave a Reply

Your email address will not be published. Required fields are marked *