SVEZA Interior and Exterior Plywood grades Defects Part 9:Edge defects caused by sanding, cutting (fringe), veneer shortage

SVEZA Interior and Exterior Plywood grades Defects Part 9:Edge defects caused by sanding, cutting (fringe), veneer shortage

http://baza.sveza.ru/eng/index.php?pid=2&pr=2&id=35&def_id=35&full=1

Veneer shortage is a missing part of veneer sheet in a plywood panel.

Fringe is a continuous or intermittent section of plywood edge with some grain not fully trimmed.

Edge defects caused by sanding, cutting (fringe), veneer shortage
Edge defects caused by sanding, cutting (fringe), veneer shortage
Edge defects caused by sanding, cutting, and veneer shortage are measured at the maximum distance between the defect’s border and the plywood sheet’s edge.
如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our articles infringe on your copyrights and interests, please email us at info@plywoodinspection.com in time and we will delete it at the first time.

Check Also

Indonesian Plywood Standard 

Indonesian Plywood Standard Standard BS British Standard IHPA International Hardwood Products Association IPS Indonesian Plywood …

Leave a Reply

Your email address will not be published. Required fields are marked *