Technical requirements for Wood Moulding

Technical requirements for Wood Moulding

There are two technical requirements for wood line: moisture content and formaldehyde emission:

1. Water content:

The moisture content of solid wood line and finger joint line before use shall not be less than 7%, and shall not be greater than the local balanced moisture content of various regions in China. The moisture content of wood-based panel line before use shall meet the requirements of corresponding wood-based panel standards.

2. Formaldehyde emission: the formaldehyde emission shall be measured for the line using finger joint material, wood-based panel and wood plastic composite material as the base material, and the limit value shall not be greater than 1.5mg/l

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our articles infringe on your copyrights and interests, please email us at info@plywoodinspection.com in time and we will delete it at the first time.

Check Also

Wood Moulding

Basic knowledge of Wood Moulding What is Wood Moulding ? First of all, its full …

Leave a Reply

Your email address will not be published. Required fields are marked *