The Process of Producing Particle Board From Sawdust

The Process of Producing Particle Board From Sawdust

A form of engineered wood, particle board was first developed in Germany by Max Himmelheber after World War II. Before that time sawdust and wood shavings were used only as fuel, but the invention of particle boards gave wood byproducts a new purpose. Particle boards are produced in many thicknesses, and are commonly used for furniture parts and insulation for walls and floors.

Refining Wood Residue

Sawdust is often mixed with other remnant pieces of wood to create a sheet of particle board. The most common particles are wood chips, shavings and flakes, which are often gathered from lumber mills, and brought in their raw state to the particle board manufacturer. The sawdust is sifted, and each particle is housed separately in accordance with its size.

Mixing and Drying

The wood materials are mixed with the sawdust in a large, cylindrical machine. The dust is combined with even proportions of the other wood particles so that each board has a similar composition of wood materials. The mixing machine also dehydrates the wood particles. Large factory machines can be calibrated as high as 1,600 degrees and extract up to 60 tons of water per hour.

Binding Ingredients

The sawdust and mixed particles are sprayed with a formaldehyde-based resin, such as urea-formaldehyde or phenol-formaldehyde, which helps bind them together. Waxes are also added to help waterproof the final product. Other binding ingredients can include fireproofing agents and pesticides to deter termites and other insects.

Sheets

The resin mixture is laid out evenly, approximately three times the thickness of the actual board. Smoothing the surface with rollers helps ensure that the board will be the same density throughout as the wood is created in one continuous mat. Pressure is applied to wood, along with hot steam (approximately 360 degrees), which helps melt the resins and compress the particles.

Finishing

Final touches include buffing, cutting and laminating. Rollers or finishing plates are used to buff and sand the wood before it is cut into standard dimensions, 8 to 10 feet wide by 24 feet long. Afterward, the boards can also be laminated or finished with a veneer, which is a thin paper covering that imitates real wood. Finished boards are packed and stored until shipment.

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our article infringes on your rights and interests, please email us in time and we will delete it at the first time.

Check Also

  OSB PANEL Manufacturing process 

  OSB PANEL Manufacturing process 

OSB PANEL Manufacturing process An oriented strand board (OSB) is a structural panel composed of …

Leave a Reply

Your email address will not be published. Required fields are marked *