Tongue and Groove Plywood Inspections and QC grading

Tongue and Groove Plywood Inspections and QC grading

Raw or film faced plywood can be tongue and grooved according to customer requirements.

Sizes:

  • Length: 100 – 4000 mm
  • Width: 260 – 3500 mm
  • Thickness: up to 50 mm

Tolerances:

  • Width: +/- 3 mm/m
  • Variation of diagonals: max 0.3 mm/m
  • To centre of T&G from base line: +/-0.2 mm

Standardprofiles:

  • H-TG1
  • H-TG3
  • Groove H-G
  • Chamfer H-L
  • Rounding H-R
  • Profile for table tops H-M 4
  • Profile for table tops H-M 11
  • H-TG2
  • H-TG4
  • Half lap H-PS
  • Partial groove H-DG
  • Profile for table tops H-M 1
  • Profile for table tops H-M 5

Edge sealing, other profiles and specific tolerances upon request.

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our articles infringe on your copyrights and interests, please email us at info@plywoodinspection.com in time and we will delete it at the first time.

Check Also

Requirements on substrate treatment for installation of film faced plywood

Requirements on substrate treatment for installation of film faced plywood During the installation of film …

Leave a Reply

Your email address will not be published. Required fields are marked *