Veneer quality control Part 6:Application of Continuous Hot Press Dryer Heated by Heat Conducting Oil to Dry Fast-growing Poplar Veneer

Veneer quality control Part 6:Application of Continuous Hot Press Dryer Heated by Heat Conducting Oil to Dry Fast-growing Poplar Veneer

Thermal conductive oil is used as heat carrier in continuous hot-pressing drying of fast-growing poplar veneer, and the effect is good. The moisture content of poplar veneer (nominal thickness 1.7mm) can be less than 8% in 2 minutes. Dry veneer is basically flat, smooth, with uniform final moisture content and no tearing. The thickness of veneer is 5.3% and the transverse grain is 4.9%. The average bonding strength of veneer is 0.812MPa, slightly higher than that of convection drying veneer with mesh belt. The results show that this method is feasible for drying fast-growing poplar veneers.

keywords of this post : veneer hot pressing ,veneer drying ,veneer moisture content ,veneer thickness ,chinese poplar veneer ,hot press dryer machine

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our article infringes on your rights and interests, please email us in time and we will delete it at the first time.

Check Also

Distribution of Eucalyptus Log Resources in China

Distribution of Eucalyptus Log Resources in China As the main fast-growing forest species in China, …

Leave a Reply

Your email address will not be published. Required fields are marked *