Why do sawtooth occur when density plates are carved

Why do sawtooth occur when density plates are carved?

Density boards can be used in various markets, especially after engraving machine, can produce beautiful, personalized decorative boards.

Carving is a combination of drilling and milling in principle. When carving a density plate, it may produce edge sawtooth phenomenon for various reasons, resulting in waste of sheet metal or cost of reprocessing. So, what are the reasons for the sawtooth in density plate engraving?

1. First of all, see if the position of the engraving machine has just been moved, resulting in the vibration of the machine during processing, resulting in the chatter of the engraving knife followed by the engraving surface is not smooth and serrated. After moving the position of the engraving machine, we should fix the four corners of the machine firmly.

carving

2. If the sawtooth phenomenon is found on the non-smooth surface of the plate, the size of the cutting tool used should be checked first. If the handle is extended too long, the deformation of the cutting tool will increase at the time of processing. This situation will lead to the non-smooth surface with sawtooth. At this time, the verticality of the spindle needs to be readjusted.

3. The non-perpendicularity of the processing table and the principal axis of the engraving machine is also one of the reasons for the sawtooth.

4. Slow spindle speed is also the cause of carving sawtooth, which can be adjusted to speed up spindle rotation.

如无特殊说明,文章均为本站原创,转载请注明出处。If there are no special instructions, the articles are original, if you want to use or reproduce, please indicate the original source www.plywoodinspection.com,If you find that our article infringes on your rights and interests, please email us in time and we will delete it at the first time.

Check Also

Help you understand the quality requirements of formaldehyde emission from plywood

Suggested collection! Help you understand the quality requirements of formaldehyde emission from plywood for home …

Leave a Reply

Your email address will not be published. Required fields are marked *