Quality Inspection Report Product Name: Beaded Paintable White Primed MDF Wall PanelsInspection Date: [Insert Date]Batch No.: [Insert Batch No.]Manufacturer: [Insert Manufacturer]Inspector: [Inspector Name] 1. Common Manufacturing Defects Checklist Defect TypeDescriptionAcceptance CriteriaInspection Result (Pass/Fail)RemarksSurface ImperfectionsScratches, dents, or uneven texture on the primed surface.Smooth, defect-freePass/Fail[Notes]Edge ChippingDamaged or rough edges along the beaded design.Clean, sharp edgesPass/Fail[Notes]Primer AdhesionPoor primer coating leading to peeling or flaking.Even, well-bonded primerPass/Fail[Notes]Warping/BowingPanel deformation (curving …

HPL & MELAMINE PLYWOOD QUALITY INSPECTION REPORT [TABLE HEADER] Date of Inspection: [DD/MM/YYYY] Inspector: [Name] Batch No.: [Number] Supplier: [Name] Manufacturing Date: [DD/MM/YYYY] [MAIN TABLE] | Category | Test Item | Standard Requirement | Test Method | Test Result | Pass/Fail | Remarks | |------------------------|----------------------------|-----------------------|----------------------|-------------|-----------|---------| | **HPL Plywood Defects** | | | | | | | | | Delamination | …

PINE PLYWOOD QUALITY INSPECTION REPORT Test CategoryTest ItemStandard RequirementTest ResultPass/FailDefect DescriptionVisual DefectsKnotsMax 3 per m²2/m²PassSmall tight knots allowedSplits/CracksNone allowedNonePass–Core GapsMax 2mm width1.5mmPassOccasional small gapsFace Veneer QualityNo open defectsMinor tearoutConditionalSanding requiredDelaminationNone allowedNonePass–Dimensional ChecksThickness Tolerance±0.3mm+0.2mmPassUniform thicknessLength/Width Tolerance±3mm+2mmPassWithin specSquareness≤2mm deviation1.5mmPass–Physical TestsMoisture Content8-12%10.2%PassProperly driedDensity500-600kg/m³540kg/m³Pass–Bending Strength (MOR)≥30MPa34MPaPassExcellent stiffnessModulus of Elasticity (MOE)4500MPa4800MPaPass–Adhesion TestsGlue Bond Strength≥1.2N/mm²1.5N/mm²PassExcellent bondingBoil Test (24hr)No delaminationPassedPassWater-resistant glueSurface QualityRoughness (Ra)≤50μm42μmPassSmooth surfaceSanding DefectsNo unsanded areasMinor …